Table of Contents
Advertisement
HOSE & REGULATOR
The Hose Valve Regulator (HVR) supplied with this appliance is an independently CSA certified product. It is
designed to connect the appliance to a 9.1 Kg/20 lbs LP Cylinder. Read and follow all instructions and warnings
on the supply hose safety tags. Clean and inspect the HVR before each use of the appliance. If there is evidence of
abrasion, wear, cuts or leaks, the HVR must be replaced prior to the appliance being put into operation. No matter
the physical appearance, replace the HVR assembly every two years. Replace only with Model #M5HPR-1.
10 PSI Fixed
Regulator
Type-1
Connector
To Connect the Hose Valve Regulator to the LP Cylinder:
• Before attaching the Type-1 Connector to the tank, ensure the LP
Cylinder Valve is fully turned off (closed).
• Confirm the Brass Valve on the HVR is turned off (closed) as well.
• Place the LP cylinder upright, and locate it at least 50.8cm/20-in
from the appliance. (See Placement of Cooker)
• Remove the Protective Cap from the Type-1 Outlet.
• Screw the Type-1 Connector on the HVR to the Type-1 Outlet on
the LP Cylinder by hand and tighten to a full stop. Do not use tools.
To Disconnect the Regulator from the LP Cylinder:
• Before disconnecting the regulator from the tank, ensure the LP
Cylinder Valve is fully turned off (closed).
• Confirm the Brass Valve is turned off (closed) as well.
• Disconnect the Type-1 Connector on the regulator from the Type-1
Outlet on the LP Cylinder.
• Replace the Protective Cap over the Type-1 Outlet.
CAUTION
Always confirm both LP Cylinder Valve and Brass
Valve are turned to the off (closed) positions before
connecting or disconnecting the HVR.
WARNING
• The hose and regulator assembly supplied with this appliance must be used.
• Do not attempt to disassemble, alter, or repair any part of the hose and regulator
assembly. Approved replacement parts can be obtained from Barbour International, Inc.
Brass Valve
121cm/48-in
High Pressure
Hose
Male Connector
(#59 Orifice)
Upright
Position
9
Replace
Dust Cap
Hand
tighten
only
Advertisement
Table of Contents
