Table of Contents
Advertisement
MAINTENANCE & CARE
Follow these simple steps to keep your appliance looking good and functioning properly for years.
1. Before each use of the appliance, light the cooker and let it run for 5-7 minutes. This initial fire will burn away the
manufacturing oil and residue. It is normal to have smoke or slight odor.
2. Make sure you clean off the cooker after each use and before storing. Wait until the cooker is completely cool,
and simply spray off the frame with a water hose to rinse away any residue from any splatter or spill-over. Use a
soft cloth if necessary. Allow to fully dry before storing. NOTE: The next time you use the cooker, it may burn off
any remaining residue from a previous spill-over, causing an odor and/or smoke.
3. Keep the appliance area clear and free from combustible materials, gasoline, and other flammable vapors and
liquids.
4. Do not obstruct the flow of combustion and ventilation air.
5. Keep the ventilation opening(s) of the cylinder enclosure free and clear from debris.
6. Always check the burner/venturi tubes for any obstructions such as insects or insect nests in the burner.
To remove burner obstructions:
A. Use a narrow bottle brush or stiff wire to run
up and down the length of the burner tube.
B. Use a water hose or compressed air to flush
out any debris.
C. If necessary, disassemble the burner by
removing the serrated nut and unscrewing
the mounting bolt from the center of the burner.
WARNING
• Never spray anything on a hot cooker frame:
A. Spraying water will give off steam that can cause burns.
B. Spray paint and other petroleum distillates can burst into flame.
• Check and clean the burner with every use. A clogged tube can lead to a fire beneath the
appliance.
7. Always turn off (close) the gas supply and disconnect the hose and
regulator from the LP cylinder to move or store.
8. To avoid damage to the regulator and minimize trip hazards,
place regulator on the appliance frame any time the hose is not
connected to the LP Cylinder.
9. Store appliance in a dry place. If storing indoors (including a shed
or garage), detach the LP cylinder and store the tank outside. For
long term storage, cover the burner and the HVR with a plastic bag.
10. Do not store this appliance, or any of its components, in a corrosive
environment. A corrosive environment can be a highly damp area,
or a saltwater/marine environment.
1 1. Metal discoloration will result from exposure to excessive heat. For hard to clean stains or discoloration of a
cooking vessel, apply a non-abrasive cleaner with a clean, damp sponge or cloth. Do not use a steel wool pad
or harsh abrasive cleanser as scratching will occur.
Wear eye protection when flushing out
the burner.
Stiff wire
with hook
14
CAUTION
Place regulator
on appliance
frame
Advertisement
Table of Contents
