Nakayama EC1350 Manual page 4

EN
CAUTION!
1. While charging, it is normal for the charger and/or battery to heat up slightly.
2. If the batteries are not used for a long time, they should be recharged every 3 months for a longer lifespan.
3. New batteries or batteries that have not been used for a long time require 5 times longer charging time to reach maximum capacity.
4. Do not charge batteries repeatedly after a few minutes of operation, as this can reduce battery life and efficiency
5. Do not use damaged batteries and do not disassemble the charger or batteries.
6. Batteries contain flammable materials, keep away from flame/heat. (Risk of explosion!)
7. Do not charge batteries outdoors or in a humid environment.
8. With the gradual reduction of the battery load, it is normal for the maximum cutting diameter to decrease.
9. Do not use the electric pruning shears while charging.
Blade oiling
Disconnect the power to the scissors before such a task
Re-apply lubricant before using the blades or after using them for more than 4 hours.
1. Keep the blades open and add 1-2 drops of lubricant to the connection between the moving and fixed
blade (as shown in the picture).
2. Open and close the blade several times to evenly distribute the lubricant.
Blade tension adjustment
Disconnect the power to the scissors before such a task
Keep the blades open and check for lateral swings. Lateral swing is an abnormal condition, which creates a gap between the two blades, leading to the gear
teeth not being able to bite properly, which can damage the mechanical structure. The blade needs to be locked (not too tight).
Blade replacement
Disconnect the power to the scissors before such a task
Remove the battery to ensure safe working conditions and replace the blade step by step as shown below.
1. Unscrew the screws with a
screwdriver and open the lid.
5. Remove the fixed blade
9. Insert the lock nut.
4
2. Remove the screws from the
blade nut retaining buckle (this
step is critical).
6. When replacing the blades,
lubricating oil needs to be added
in between.
After replacement, clean the tool, turn it on to test it and close the blade to finish.
Note: Shim and moving blade can be adjusted independently. Do not be afraid of the blade opening being too small
after replacing it. After switching on, the normal opening size is restored automatically.
WWW.NIKOLAOUTOOLS.GR
3. Remove the blade nut.
7. Replace each blade.
Refueling
point
4. Unscrew the pin and remove
the moving blade
8. Insert nut.