Locomotive Basics; Locomotive Switch Locations; Assigning Your Locomotive A New Id# (Legacy And Tmcc) - Lionel LEGACY 4-4-0 Owner's Manual

Locomotive basics

Locomotive switch locations

T
he functions of your locomotive's switches are outlined below. Refer to Figure 5 for the location
of the switches. The instructions below are specific to this particular locomo-
tive; note that available features (and switches) may differ from other loco-
motives and sets.
Program/Run Switch
Used to assign an ID# and reprogram the locomotive in LEGACY and Command operation when
the switch is in the PGM position. Also used to "lock" your locomotive in a single direction, or
neutral, in conventional operation when the switch is placed in the PGM position.
Remove hatch
Figure 5. Switch location
Assigning your locomotive a new ID#
F
or operation in the LEGACY or Command Control environment, you will want to give your
locomotive a unique ID#. Your locomotive will respond to commands associated with its ID#
while all other units will disregard these commands. This procedure is not necessary for
conventional (non-Command) operation.
1. Slide the RUN/PGM switch to PGM per Figure 5.
2. Place the locomotive and tender on the track and connect the wired tether per
Figure 1 on page 5.
3. Connect the Command Base and plug it in.
4. Power up the track.
5. Press ENG on the CAB-1 or CAB-2 remote.
6. Enter the unique ID#. Choose any number from 1 to 98 that has not been
assigned to another locomotive (ENG). We recommend using a part of your
locomotive's road number.
Note!
All LEGACY locomotives respond to ENG 99. We recommend that you reserve ID# 99 as a
"universal" ID#.
7. Press SET. The locomotive's headlight will flash.
8. Slide the program/run switch back to the RUN position.
The locomotive's ID# has been set. Be sure to record the new ID# for your reference.
Program/Run switch
8