Seneca R-KEY-LT User Manual page 19

Used to Set the number of bits for the serial communication.
PORT #1 PARITY
Used to Set the port parity (None, Odd or even).
PORT #1 STOP BITS
Used to Set the port parity (1 or 2; note that if the parity is set, only 1 bit can be used).
PORT #1 TIMEOUT
Used to Set the timeout on Modbus Master mode before making a new call.
WEB SERVER PORT
Used to Set the TCP-IP port for the Webserver.
WEB SERVER AUTHENTICATION USER NAME
Used to Set the User Name for accessing the Webserver (if User Name and Password are leave empty no
authentication is require for webserver access)
WEB SERVER AUTHENTICATION USER PASSWORD
Used to Set the Password for accessing the Webserver (if User Name and Password are leave empty no
authentication is require for webserver access)
IP CHANGE FROM DISCOVERY
Used to Set if a user is allowed to change IP configuration from the software "Seneca Discovery Device"
If "Modbus Serial to Ethernet" mode is selected you need to compile also the Modbus TCP-IP servers
parameters:
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
www.seneca.it
Doc. MI004870-EN
Rev. 1.0.0.0
R-KEY-LT
Page 19