Seneca R-KEY-LT User Manual page 17

Now click on "Setup" for configure the device:
If you need to reset to the default parameters click on "FACTORY DEFAULT" button.
In this page you can save and load a previous configuration.
The first column represents the parameter name, the second column (current) it's the current parameter value.
The last column can be used for changing the current configuration.
The parameters are explained below:
DHCP
Disable: A static Ip address is used
Enable: The IP address, the IP-Mask and the Gateway address are obtained from the DHCP server.
The R-KEY IP address can be obtained with the Device Discovery utility.
If R-KEY-LT is configured with the ip set to DHCP but the DHCP server is not active,
after 5 minutes from the power up the R-KEY-LT will force the following fault ip address:
R-KEY-LT mac address =
STATIC IP ADDRESS
Static IP address when DHCP is Disable
STATIC IP MASK
mask when DHCP is Disable
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
WARNING!
169.254.x.y
Where x.y are the last 2 MAC address values.
For example:
C8:F9:81:11:1A
Fault ip address =
www.seneca.it
(hexadecimal values)
169.254.17.26
Doc. MI004870-EN
R-KEY-LT
Rev. 1.0.0.0 Page 17