First Access To The Web Server Without A Dhcp Server - Seneca R-KEY-LT User Manual

If R-KEY-LT is configured with the ip set to DHCP but the DHCP server is not active,
after 5 minutes from the power up the R-KEY-LT will force the following fault ip address:
R-KEY-LT mac address =

FIRST ACCESS TO THE WEB SERVER WITHOUT A DHCP SERVER

5.2.
1) Switch OFF the R-KEY-LT
2) Force to static ip configuration by setting on SW2:
DIP 1 OFF
DIP 2 ON
This will force the ip to 192.168.90.101 static ip address
3) Switch ON the R-KEY-LT
4) Set to use the flash configuration by setting on SW2:
DIP 1 OFF
DIP 2 OFF
5) Download from here:
http://www.seneca.it/products/r-key-lt
the Seneca Discovery Device tools then install it.
6) Launch the Seneca Discovery Device tool and click on the "Search" button, a list of Seneca devices
will be found. Now select the R-KEY-LT device:
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
WARNING!
169.254.x.y
Where x.y are the last 2 MAC address values.
For example:
C8:F9:81:11:1A
Fault ip address =
www.seneca.it
(hexadecimal values)
169.254.17.26
Doc. MI004870-EN
R-KEY-LT
Rev. 1.0.0.0 Page 13