Debug Leds; Default Configuration - Seneca R-KEY-LT User Manual

DEBUG LEDS

LED
PWR
PWR
PWR
RX
TX

DEFAULT CONFIGURATION

The default configuration is:
IP: DHCP mode
Mode: Modbus Ethernet to Modbus RTU
Serial: Baud rate 38400,8bit ,No parity,1 stop bit
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
STATE
OFF
FLASHING
ON
FLASHING
FLASHING
www.seneca.it
User Manual
R-KEY-LT is switched off
R-KEY-LT is waiting an ip address from the DHCP server
R-KEY-LT has acquired an IP address
Data reception on serial port
Data transmission on serial port
MEANING
Doc. MI004870-EN
Rev. 1.0.0.0
R-KEY-LT
Page 10