Dip Switches Sw1 And Sw2 Configuration; Web Server Configuration - Seneca R-KEY-LT User Manual

DIP SWITCHES SW1 AND SW2 CONFIGURATION

5.4.
For reboot the device you can power off/on the power supply or press the "Reset" button until all leds
RS485 BUS POLARIZER ON
RS485 BUS POLARIZER OFF
USE CONFIGURATION FROM FLASH
WRITE AND USE FACTORY DEFAULT
CONFIGURATION (WITH DHCP ON)
FORCE IP TO 192.168.90.101

WEB SERVER CONFIGURATION

5.5.
For access to the internal webserver type in a browser the R-KEY-LT ip address, for example:
http://192.168.90.101
then enter the username and password (default: user name = admin, password = admin).
The first page is the "Status" page:
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
WARNING!
Dip switches configuration are active only after a reboot!
are ON (about 5 seconds).
SW1 ACTION
SW2 ACTION
(DEFAULT)
RESERVED
www.seneca.it
SW1 DIP1 SW1 DIP2
ON
OFF OFF
SW2 DIP1 SW2 DIP2
OFF OFF
ON
OFF
ON OFF
Doc. MI004870-EN
R-KEY-LT
ON
ON
ON
Rev. 1.0.0.0 Page 16