Configuring The Device; First Access To The Web Server With A Dhcp Server - Seneca R-KEY-LT User Manual

CONFIGURING THE DEVICE

For reboot the device you can power off/on the power supply or press the "Reset" button until all leds

FIRST ACCESS TO THE WEB SERVER WITH A DHCP SERVER

5.1.
1) Switch OFF the R-KEY-LT
2) Force to flash the factory configuration by setting on SW2:
DIP 1 ON
DIP 2 ON
This will change the last configuration to factory default (with the IP set to DHCP, web server access
set to admin/admin).
3) Switch ON the R-KEY-LT
4) Set to use the flash configuration by setting on SW2:
DIP 1 OFF
DIP 2 OFF
5) Download from here:
http://www.seneca.it/products/r-key-lt
the Seneca Discovery Device tools then install it.
6) Launch the Seneca Discovery Device tool and click on the "Search" button, a list of Seneca devices
will be found. Now select the R-KEY-LT device:
ALL RIGHTS RESERVED. NO PART OF THIS PUBLICATION MAY
BE REPRODUCED WITHOUT PRIOR PERMISSION.
User Manual
WARNING!
Dip switches configuration are active only after a reboot!
are ON (about 5 seconds).
www.seneca.it
Doc. MI004870-EN
Rev. 1.0.0.0
R-KEY-LT
Page 11