Angelo Po 2G0FA0A Use And Installation Manual page 34

To carry out this operation, proceed as follows.
1 - Remove the burner cap (A) and the burner (B).
2 - Clean the burner and the flame cap thoroughly
and check that the holes in it are not blocked.
3 - Clean the ignition slot in the burner regularly.
4 - Clean the hob.
5 - After use, clean the accessories with a suitable
grease-remover product. If possible, wash in
the dishwasher.
6 - Dry the surfaces and reassemble the compo-
nents.
Caution - warning
Never pour water or allow dirt to fall into the
burner as this will cause the burner to mal-
function or block the nozzle.
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (C) and remove the control
panel (B).
4 - Undo the screw (D) of the pressure connection.
IT
5 - Connect the pressure gauge (E) to the pressure
test point (F).
GB
6 - Turn the gas supply tap back on.
DE
FR
ES
English
CLEANING THE HOB, BURNERS AND ACCESSORIES
CHECKING GAS PRESSURE
A
7 - Light all the burners and turn the knobs to the
full flame setting (see page ), then check that
the pressure reading complies with the values
provided in the table at the back of the manual.
8 - Switch off the burner, turn off the gas supply tap
and disconnect the pressure gauge.
9 - Restore the initial conditions after completing
the operation.
B
C
- 10 -
A
B
F
D
E
IDM-39608800200.tif
IDM-39608800300.tif