A1
STEP 1
Choose a location to mount your Gateway and the antenna. For the
Gateway (pictured above), make sure there is access to a 120VAC out-
let and, preferably, an ethernet connection. The antenna should be in a
good line-of-sight to sensors within 20 feet of the Gateway location.
STEP 2
Attach mount brackets to the enclosure
with the included screws. Brackets fit on
protruding screwholes on the back of
the enclosure. Then, use drywall screws
and attach unit to the wall location.
STEP 3
Attach the antenna as shown. This Gateway has been setup with multiNetwork cell connection that will
automatically connect when powered. If cell service is unavailable it is possible to connect the Gateway
ethernet plug to a network router or switch.
QUICK SETUP GUIDE
BCGW.XXLLC
BINCLOUD GATEWAY
Tools needed: drill and bit, phillips screwdriver, drywall/
wood screws, ethernet cable, pliers. Screws and plas-
tic plugs, A1, can be used to secure the top cover.
control
room
1
power
ethernet
4
3
laser
sensor
2
1. Gateway
2. Wire through wall to antenna
3. Antenna mounted outside with line of site to sensor
4. Laser sensor mounted on vessel
Need help?
Do you have a question about the BINCLOUD BCGW LLC Series and is the answer not in the manual?
Questions and answers