BINMASTER BINCLOUD BCGW.02LLC Quick Setup Manual

A1
STEP 1
Choose a location to mount your Gateway and the
antenna. For the Gateway (pictured above), make sure
there is access to a 120VAC outlet. The antenna should
be in a good line-of-sight to sensors within 20 feet of
the Gateway location.
1. Gateway
2. Wire through wall to antenna
3. Antenna mounted outside with line of site to sensor
4. Laser sensor mounted on vessel
STEP 2
Attach mount brackets to the enclosure
with the included screws. Brackets fit on
protruding screwholes on the back of
the enclosure. Then, use drywall screws
and attach unit to the wall location.
STEP 3
Open the Gateway cover and find the 4-20mA adapter terminal (circled).
Connect the positive sensor wire to the terminal labeled "+24VDC"
Connect the negative sensor wire to the terminal block labeled "INPUT."
QUICK SETUP GUIDE
BCGW.02LLC
BINCLOUD GATEWAY
Tools needed: drill and bit, phillips screwdriver, drywall/
wood screws, ethernet cable, pliers. Screws and plas-
tic plugs, A1, can be used to secure the top cover.
control
3
room
1
2
Positive = red
Negative = black
4-20mA
sensor
4
laser
sensor
power
ethernet