A1
STEP 1
Choose a wall location to mount your Gateway. Make sure there is access to a 120VAC outlet and, preferably, an ethernet connection.
STEP 2
Attach mount brackets to the enclosure
with the included screws. Brackets fit on
protruding screwholes on the back of
the enclosure. Then, use drywall screws
and attach unit to the wall location.
STEP 3 FOR 4-20mA SENSORS
(Modbus sensors skip to STEP 3.1)
Open the cover and find the 4-20mA adapter terminal (circled).
Connect the positive sensor wire to the terminal labeled "+24VDC"
Connect the negative sensor wire to the terminal block labeled "INPUT".
Ground wires go to "GND".
Wiring for a 2-wire sensor,
powered by the current loop
4-20mA
sensor
925-0413
Wiring for a 3-wire sensor,
powered by Yocto-4-20mA-Rx
(max 80mA)
4-20mA
sensor
QUICK SETUP GUIDE
BCGW.02XXE
BINCLOUD GATEWAY
Tools needed: drill and bit, phillips screwdriver, drywall/
wood screws, ethernet cable, pliers. Screws and plas-
tic plugs, A1, can be used to secure the top cover.
Base photo of Gateway. Some units include extra terminals.
Wiring for a 4-wire sensor, with an
independent power supply.
4-20mA
sensor
Power
source
Wiring for 3-wire sensor, with
independent power supply with
common ground.
4-20mA
sensor
Power
source
02/13/2023
Need help?
Do you have a question about the BINCLOUD BCGW.02XXE and is the answer not in the manual?
Questions and answers