Digilock Next Mech Dial Combo Product Manual

Lock Parts

Front Unit
Locked Position
Key Slot
Accommodates door
thickness up to 20 mm
Spacer required* for door

Installation Guide

thickness less than 8 mm
Mounting plate
Accommodates door
thickness up to 20 mm
Spacer required* for door
Accommodates door
thickness less than 8 mm thickness up to 20 mm
Spacer required* for door
Mounting plate Mounting
thickness less than 8 mm
Screws
Mounting plate
Mounting
Screws
Mounting
Screws
Manager key Removal key

Operate with a Combination

Factory default combination 0-0-0-0
To Lock:
Manager key Removal key
1.
Manager key Close the door. Removal key
2.
Make sure the knob is in the
Factory default combination 0-0-0-0
Factory default combination 0-0-0-0
unlocked position.
3.
Set any 4-digit combination.
4.
Turn the knob to the locked
position.
5.
Scramble the combination.
Product Guide
Rear Unit
Unlocked Position
Core Removal
Position
Comibination Dial
Reset Pin Holes
Spacer Requirements
Door thickness
To Unlock:
1.
Enter your 4-digit
combination.
2.
Turn the knob to the
unlocked position.
3.
Open the door.
4.
Scramble the combination.
Dial Combo
Cam in Locked Position
must overlap Strike
Mortise Hole Dimensions
Plate by at least ¼"
(6.35 mm)
Mortise Hole Dimensions
Cam in Locked Position
must overlap Strike
Plate by at least ¼"
(6.35 mm)
Cam in Locked Position
must overlap Strike
Plate by at least ¼"
(6.35 mm)
Spacer Requirements
Door thickness Screw type
0 – 5 mm M3×10
5 – 8 mm M3×14
8 – 12 mm M3×10
12 – 16 mm M3×14
16 – 20 mm M3×18
Spacer Requirements
Door thickness Screw type *Spacer required

Operate with a Manager Key

Screw type *Spacer required
0 – 5 mm M3×10
✓
0 – 5 mm M3×10
5 – 8 mm M3×14
✓
5 – 8 mm M3×14
8 – 12 mm M3×10
8 – 12 mm M3×10
12 – 16 mm M3×14
To Unlock with Manager Key:
12 – 16 mm M3×14
16 – 20 mm M3×18
16 – 20 mm M3×18
1.
Insert the Manager Key.
2.
Turn the knob to the
unlocked symbol.
3.
Open the door.
Note: The Manager key provides instant access but does not erase
the code. The original code will continue to operate the lock even when
unlocking with the Manager Key.
If opened in error, use the Manager Key to turn the lock to the locked
position.
If the code is forgotten, follow the Reset Combination steps to make the lock
available for another user.
Shared Use
Cam
Mortise Hole Dimensions
min. 6.35 mm
31.5 mm
Accommodates door
thickness up to 20 mm
min. 6.35 mm
Spacer required* for door 31.5 mm
min. 6.35 mm
thickness less than 8 mm
31.5 mm
Mounting plate
Mounting
Screws
*Spacer required
✓
✓
✓
✓
Note "M" for
Manager on key
Manager key Removal key
Factory default combination 0-0-0-0