Terminals Of Projector - Sanyo PLC-XF1000 Owner's Manual

Terminals of Projector

The projector has two replaceable Interface board slots. The projector's functions can be extended by installing
the optional interface boards into the terminal slots. 2 vacant slots (Input 3 and 4) are provided in your
purchasing the projector. For the Optional Interface Boards, contact sales dealer where you purchased the
projector.
INPUT/OUTPUT
TERMINALS
Replacement of Terminal
Note:
✔
• In the replacement of interface board, turn off the
projector, press the Main On/Off Switch to Off and
unplug the AC power cord from the AC outlet.
1
Remove 2 Screws from an interface board.
2
Pull out the interface board.
3
Replace the interface board. Insert a new interface
board along Guide to fit Socket to inside Plug.
4
Tighten screws to secure the interface board.
NOTES ON ORDERING OR USING
OPTIONAL INTERFACE BOARD
When ordering or using Optional Interface Board, contact
your sales dealer. When contacting the sales dealer, tell the
Option Control Number (Op.cont.No.) in the menu that is
located on the bottom of the information menu.
(See page 28)
2 TERMINAL SLOTS (Factory set)
DVI / D-sub 15 Terminal 5-BNC / VideoTerminal
Figure shows Dual-SDI terminal.
Plug
Installation
Screws
Guide
Socket
19