Turning Off The Projector - Sanyo PLC-XF1000 Owner's Manual

Basic Operation

Turning Off the Projector

1
Press the ON/STAND-BY button on the side control
or on the remote control, and "Power off?" appears
on the screen.
2
Press the ON/STAND-BY button on the side control
or on the remote control again to turn off the
projector. The LAMP indicator lights bright and the
READY indicator turns off. After the projector is
turned off, the cooling fans operate. You cannot turn
on the projector during this cooling down period.
When the projector has cooled down enough, the
3
READY indicator lights green and then you can
turn on the projector. To turn off the MAIN ON/OFF
Switch, wait until the projector is completely cooled
down.
4
Unplug the AC power cord from the AC outlet.
TO MAINTAIN THE LIFE OF THE LAMP , ONCE YOU
TURN THE PROJECTOR ON, WAIT AT LEAST FIVE
MINUTES BEFORE TURNING IT OFF .
DO NOT UNPLUG THE AC POWER CORD WHILE
COOLING FANS ARE RUNNING OR BEFORE THE
READY INDICATOR LIGHTS GREEN AGAIN.
OTHERWISE IT WILL RESULT IN SHORTENING OF
THE LAMP LIFE.
DO NOT OPERATE THE PROJECTOR CONTINUOUSLY
WITHOUT REST. CONTINUOUS USE MAY RESULT
IN SHORTENING THE LAMP LIFE. TURN OFF THE
PROJECTOR AND LET STAND FOR ABOUT AN HOUR
IN EVERY 24 HOURS.
✔ Note:
•When the On start function is set to "On, " the projector
will be turned on automatically by connecting the AC power
cord to an AC outlet (p.53).
•The running speed of cooling fans is changed according to
the temperature inside the projector.
•Do not put the projector in a case before the projector is
cooled enough.
•If the WARNING TEMP . indicator blinks red, see "Warning
Indicators" on page 65.
•The projector cannot be turned on during the cooling
period with the READY indicator turned off. You can turn it
on again after the READY indicator becomes green again.
24
"Power off?" disappears after 4 seconds.