Terminals And Connectors - Sanyo PLC-XF1000 Owner's Manual

Terminals and Connectors

t
q SERIAL PORT IN TERMINAL
If you control the projector by computer, you must
connect a cable (not supplied) from your computer
to this terminal.
w SERIAL PORT OUT TERMINAL
This terminal outputs signal from SERIAL PORT IN.
More than two projectors can be controlled with
one computer by connecting SERIAL PORT IN of
another projector to this terminal.
USB CONNECTOR (Series B)
e
USB connector is to used to service the projector.
R/C jACK
r
When using the wired remote control, connect the
wired remote control to this jack with a remote
control cable (not supplied).
RESET button
[
A built-in micro processor which controls this unit may
occasionally malfunction and need to be reset. This can be done
by pressing the RESET button with a pen, which will shut down
and restart the unit. Do not use the RESET function excessively.
u
y
t DVI INPUT TERMINAL
Connect computer output (Digital/DVI-D type) to
this terminal (p.20).
HD (HDCP Compatible) signal can be also
connected (p.21).
y D-sub 15-PIN INPUT TERMINAL
Connect computer output (Analog D-sub 15-pin
type) to this terminal (pp.20–21).
5 BNC INPUT jACKS
u
Connect the component or composite video
output signal from video equipment to VIDEO/Y,
Pb/Cb, and Pr/Cr jacks or connect the computer
output signal (5 BNC Type [Green, Blue, Red,
Horiz. Sync, and Vert. Sync.]) to G, B, R, H/V, and V
jacks (pp.20–21).
i S-VIDEO INPUT jACK
Connect the S-VIDEO output signal from video
equipment to this jack (p.21).
Part Names and Functions
q w
e
r
✽
i
11