Sanyo PLC-XF1000 Owner's Manual page 52

Setting
Remote control
The eight different remote control codes (Code 1–Code 8) are
assigned to the projector; the factory-set, initial code (Code 1)
and the other seven codes (Code 2 to Code 8).
The same code should be set on both the projector and the
remote control. For example, operating the projector in "Code
7" , the remote control code also must be switched to "Code 7" .
To change the code for the projector;
Select a remote control code in this Setting Menu.
To change the code for the remote control;
Check the Reset Switch to "Use position" in the compartment
lid on the back of the remote control.
And then while holding down the MENU button, press and
release the IMAGE ADJ. button the number of corresponding
times you would like to set the number of the remote control
code for the projector. (See page 16)
To reset the code for the remote control;
Slide the Reset Switch to "Reset position" in the compartment
lid on back of the remote control.
RC sensor
Select a location of the infrared remote receiver of the remote
control. See "Remote Control Receivers and Operating Range"
on page 15 for details.
Both ......... Activate both the front and back receiver.
Front ........ Activate only the front receiver.
Back ......... Activate only the back receiver.
Power management
For reducing power consumption as well as maintaining
the lamp life, the Power management function turns off the
projection lamp when the projector is not used for a certain
period.
If the input signal is interrupted and no button is pressed for
more than 30 seconds, the timer display with "No signal"
appears. It starts the countdown until the lamp is turned off. The
countdown time can be set between 1 and 30 minutes.
Use the Point 7 8 buttons to set the countdown timer.
Select one of the following options:
Ready . . . . When the lamp has been fully cooled down, the
READY indicator starts blinking. In this condition,
the projection lamp is turned on if the input
signal is reconnected or any button on the side
control or remote control is pressed .
Shutdown . . When the lamp has been fully cooled down, the
power is turned off.
Off . . . . . . . Power Management function is off.
✔ Note:
•Factory default is "Ready: 5 min. "
•When the shutter is closed while the Power management function
is working, the Power management function is released.
52
Remote control
When pressing the SELECT button at
Remote control, the Remote control
code menu appears.
Power management
Time left before the lamp is off
Press the SELECT button at Power
management and the dialog box
appears. Use the Point 7 8 buttons
to choose one of the three options.
Press the Point d button to select
the timer, and then use the Point 7
8 buttons to set the timer.