Manual
HUMLOG 10
3 HUMLOG 10 with Internal Sensors
The sensors for temperature and relative humidity, the corresponding sensor
adapters, and the serial interface (RS232) are located on this module.
Illustration: Module with Internal Sensors
Necessary calibration intervals are dependent on the environm ental conditions and
the requirements of the permissible tolerance deviations.
A single point calibration of the internal sensors can be carried out using a
comparison standard. The captured offset values can be entered in the SmartGraph
software under: Measuring Instrument / Manage Measuring Instrument / Sensor
Electronics.
Two point calibrations can only be carried out in the factory.
Page 6 of 17