Table of Contents
Advertisement
Manual
Alarm function: the datalogger is equipped with an alarm function on both channels
(temperature and humidity) which enables the user to set minimum as well as
maximum limit values.
The red LED will flash in case of an alarm.
If an alarm occurs while the HUMLOG10 is recording, the green LED will switch off
and the red LED will start flashing.
As soon as the measured values have become normal again, both LEDs will flash to
signal that an alarm came up. This can be reset by reading out the memory.
Measuring value
Set point
LED Green
LED Red
Timing Diagram: HUMLOG 10 THC alarms
HUMLOG 10
Readout of data memory
Page 12 of 17
Advertisement
Table of Contents
