Switching On The Humlog - E+E Elektronik HUMLOG 10 Manual

Manual

9 Switching on the HUMLOG 10

Just to take care of the battery the HUMLOG 10 the HUMLOG 10 is switched off
during the delivery period.
Commissioning:
 install and open the enclosed evaluation software SmartGraph on your PC
(insert Disk 1/2 and run: setup_humlog10.exe)
 Connect the data logger and the serial interface of your PC using the supplied
transfer - cable
 Open the menu – selection instrument and chose the command read
configuration
As soon as the first communication has been successfully the measuring values
appear on the display and the HUMLOG is ready for operation.
Remark:
If difficulties should occur during the communication kindly check your interface –
settings. (further information see menu selection help within the SmartGraph
software)
HUMLOG 10
Page 16 of 17