Changing The Battery - E+E Elektronik HUMLOG 10 Manual

Manual HUMLOG 10

7 Changing the Battery

When the indication BAT flashes in the upper line of the display, the battery must be
changed.
In order to do this, please first remove the Sensor Module (see Changing the Sensor
Module).
Please remove the four screws on the rear of the Display Module, using a suitable
screwdriver.
Lay the Display Module on a flat surface, with the display facing upwards, and
carefully remove the upper part of the plastic cover.
Now remove the old battery and fit the new battery (Type: LS14500/Saft, 3.6V; Order
No: HA 03 01 02) into the holder.
Important: Please observe the correct polarity of the battery and read the safety tips
on the battery.
The BAT indication now disappears and the measureme nt values are shown again
on the display.
The battery should be changed annually. Frequent data transfer with the PC and low
sample rates reduces battery life.
Illustration: Opening the HUMLOG 10 Illustration: Changing the battery
to change the battery
Page 14 of 17