The Rinse Aid Empty Notification; The Rinse Aid Level - Zanussi ZSFN132W1 User Manual

How to set the water softener level
The appliance must be in programme selection
mode.
Make sure that the programme marker on the knob
is in the on/off position.
1. To enter the user mode, press and hold
the same time turn the knob counterclockwise
until the programme marker indicates the first
programme. Release the
indicators and on/off start flashing.
The intermittent flashing of
setting, e.g. 5 flashes + pause + 5 flashes = level
5.
2. Press repeatedly to change the setting.
Each pressing of
number. After reaching level 10, the count
starts again from level 1.
3. To confirm the setting, turn the programme
knob until the programme marker is again in the
on/off position

THE RINSE AID EMPTY NOTIFICATION

The rinse aid helps to dry the dishes without
streaks and stains. It is automatically released
during the final rinse.
When the rinse aid chamber is empty, the rinse aid
indicator turns on. If the drying results are
satisfactory while using multi-tablets only, you can
deactivate the notification for refilling the rinse aid.
However, for best drying performance, always use
rinse aid.
If standard detergent or multi-tablets without rinse
aid are used, activate the notification to keep the
rinse aid refill indicator active.
How to deactivate the rinse aid empty
notification
The appliance must be in programme selection
mode.
Make sure that the programme marker on the knob
is set to the on/off position.
1. To enter the user mode, press and hold
the same time turn the knob counterclockwise
until the programme marker indicates the first
programme. Release
and on/off start flashing.
2. Turn the knob counterclockwise until the
programme marker indicates the second
programme.
The indicator shows the current setting:
10
. At
when the
shows the current
increases the level
. At
when the indicators
• is on = the rinse aid empty notification
is activated.
• is off = the rinse aid empty notification
is deactivated.
3. Press to change the setting.
4. To confirm the setting, keep turning the
programme knob until the programme marker is
back in the on/off position.

THE RINSE AID LEVEL

It is possible to set the released quantity of rinse
aid between level 1 (minimum quantity) and level 8
(maximum quantity). Level 0 deactivates the rinse
aid dispenser and no rinse aid is released. Factory
setting: level 5.
How to set the rinse aid level
The appliance must be in programme selection
mode.
Make sure that the programme marker on the knob
is set to the on/off position.
1. To enter the user mode, press and hold
the same time turn the knob counterclockwise
until the programme marker indicates the first
programme. Release
and on/off start flashing.
2. Turn the knob counterclockwise until the
programme marker indicates the third
programme.
The indicator shows the current setting, e.g. 5
flashes + pause + 5 flashes = level 5.
3. Press to change the setting.
4. To confirm the setting, keep turning the
programme knob until the programme marker is
back in the on/off position.
AIRDRY
AirDry improves the drying results with less energy
consumption. The appliance door opens
automatically during the drying phase and remains
ajar.
. At
when the indicators