Table of Contents
Advertisement
Problem and alarm code
The appliance trips the circuit-beaker.
Refer to "Before first use", "Daily
use", or "Hints and tips" for other
possible causes.
Once you have checked the appliance, press the
start button. If the problem occurs again, contact
an Authorised Service Centre.
For alarm codes not described in the table, contact
an Authorised Service Centre.
THE DISHWASHING AND DRYING RESULTS ARE NOT SATISFACTORY
Problem
Poor washing results.
Poor drying results.
There are whitish streaks or blu-
ish layers on glasses and dishes.
There are stains and dry water
drops on glasses and dishes.
20
Possible cause and solution
•
The amperage is insufficient to supply simultaneous-
ly all the appliances in use. Check the socket am-
perage and the capacity of the meter or turn off one
of the appliances in use.
•
Internal electrical fault of the appliance. Contact an
Authorised Service Centre.
Possible cause and solution
•
Use more intensive washing programmes.
•
Clean spray arm jets and the filter. Refer to "Care and
Cleaning".
•
Refer to "Daily use", "Hints and tips" and basket loading
leaflet.
•
Tableware has been left for too long inside the closed appli-
ance.
•
There is no rinse aid or the dosage of rinse aid is not suffi-
cient. Fill the rinse aid dispenser or set the dosage of rinse
aid to a higher level.
•
Plastic items may need to be towel dried.
•
For the best drying performance activate the function AirDry.
•
Always use the rinse aid, even with multi-tablets.
•
The release quantity of rinse aid is too high. Adjust the rinse
aid dosage to a lower level.
•
The quantity of detergent is too high.
•
The released quantity of rinse aid is not sufficient. Adjust the
rinse aid dosage to a higher level.
•
The quality of the rinse aid can be the cause.
WARNING! We do not recommend
using the appliance until the problem
has been completely fixed. Unplug the
appliance and do not plug it in again
until you are certain that it operates
correctly.
Advertisement
Table of Contents
