• This appliance is intended to be used in • Make sure not to cause damage to the water household and similar applications such as: hoses. – Staff kitchen areas in shops, offices and other working environments – Farm houses www.zanussi.com...
Warning! Risk of electrical shock, fire or burns. • Do not put flammable products or items that are wet with flammable products in, near or on the appliance. Control panel On/off indicator Delay button Programme marker Start button Indicators Programme knob www.zanussi.com...
Contact your local water authority to know softener agrees with the water hardness in the water hardness in your area. your area. If not, adjust the water softener. 2. Fill the salt container. 3. Fill the rinse aid dispenser. www.zanussi.com...
Page 5
= level 5 3. Press the start/cancel button one time to increase the water softener level by one step. The end indicator light shows the new level. 4. Turn the programme knob to the off posi- tion to save the operation. www.zanussi.com...
2. Turn the knob until the programme marker is aligned with the programme you want to set. 3. Load the baskets. Set the correct programme for the type of 4. Add the detergent. load and the degree of soil. 5. Start the programme. www.zanussi.com...
3. Turn the programme knob until the pro- rinse aid dispenser. gramme marker is aligned with the pro- 1. Adjust the water softener to the lowest level. gramme you want to set. • The on/off indicator comes on. www.zanussi.com...
This • Remove remaining food from the items. makes sure that the water softener uses the • Make soft the remaining burned food on the correct quantity of dishwasher salt and water. items. www.zanussi.com...
Important! An incorrect position of the filters plug from the mains socket. can cause bad washing results and damage to the appliance. Dirty filters and clogged spray arm de- crease the washing results. Make a check regularly and, if necessary, clean them. www.zanussi.com...
The appliance does not start or it stops during With some problems, different indicators operation. flash continuously or intermittently at the Before you contact the Service, refer to the in- same time to show an alarm code. formation that follows for a solution to the prob- lem. www.zanussi.com...
Page 11
• The released quantity of rinse aid is too If other alarm codes appear, contact the Serv- much. Adjust the rinse aid selector to a lower ice. position. • The quantity of detergent is too much. www.zanussi.com...
By ensuring this product where you purchased the product. is disposed of correctly, you will help prevent potential negative consequences for the • Discard correctly the packaging material. Re- cycle the materials with the symbol www.zanussi.com...