Table of Contents
Advertisement
1. Press and hold Delay and XtraDry until the
indicators
flash and the display is blank.
As the appliance stores the saved settings, there is
no need to configure it before every cycle.
ADJUSTING THE WATER SOFTENER
Make sure the appliance is in user mode.
1. Press Program.
•
The indicators
off.
•
The indicator
THE WATER HARDNESS TABLE
German degrees
(°dH)
47 - 50
43 - 46
37 - 42
29 - 36
23 - 28
19 - 22
15 - 18
11 - 14
4 - 10
<4
1) Factory setting
2) Do not use salt at this level.
DEACTIVATING THE RINSE AID EMPTY
NOTIFICATION
Make sure the appliance is in user mode.
1. Press Option.
•
The indicators
off.
•
The indicator
•
The display shows the current setting:
–
= the rinse aid empty notification
is activated.
–
= the rinse aid empty notification
is deactivated.
2. Press Option to change the setting.
,
,
and
,
and
still flashes.
French degrees
(°fH)
84 - 90
76 - 83
65 - 75
51 - 64
40 - 50
33 - 39
26 - 32
19 - 25
7 - 18
<7
,
and
still flashes.
•
The display shows the current setting: e.g.
2. Press Program to change the setting.
3. Press on/off button to confirm the setting.
If you use detergent or multi-tablets
containing salt and the hardness of
your water is lower than 21°dH, you
can set the lowest water softener level.
It deactivates the salt refill indicator. In
other cases, set the proper water
are
hardness level to keep the salt refill
indicator active.
mmol/l
8.4 - 9.0
7.6 - 8.3
6.5 - 7.5
5.1 - 6.4
4.0 - 5.0
3.3 - 3.9
2.6 - 3.2
1.9 - 2.5
0.7 - 1.8
<0.7
3. Press on/off button to confirm the setting.
If the drying results are satisfactory
while using multi-tablets only, it is
possible to deactivate the notification.
However, for best drying performance,
are
always use rinse aid.
ADJUSTING THE RINSE AID LEVEL
Make sure the appliance is in user mode.
1. Press Delay.
•
The indicators
= level 5.
Clarke degrees
58 - 63
53 - 57
46 - 52
36 - 45
28 - 35
23 - 27
18 - 22
13 - 17
5 - 12
< 5
,
are off.
Water softener
level
10
9
8
7
6
1)
5
4
3
2
2)
1
and
7
Advertisement
Table of Contents
