Advertisement
4
Software Advanced Setting
1. Advanced Setting Parameters for Software
The following items are the main functions and configurations to the software
advanced setting, please refer the user manual for more information.
http://ftp.icpdas.com.tw/pub/cd/usbcd/napdos/zigbee/zt_series/document/zt-iog/
-
Disconnection Detection :
-
I/O Channel Pair Relationship :
-
Other Parameters :
2. Software Setting Steps
The following steps are used to start the advanced setting via software.
As the ZT-20xx-IOG device does not include a COM port, the user must
①
prepare a ZigBee converter, e.g. ZT-USBC, ZT-2550 or ZT-2570, to convert
the signal to wireless signal via the USB, RS-232 or RS-485 interface for
remote setting the ZT-20xx-IOG module.
For building the wireless communication of the ZT-20xx-IOG and the
②
ZigBee converter, first, set up the following parameters of the ZigBee
converter via the "ZT-2000 Configuration Utility", so it can wirelessly
communicate with the ZT-20xx-IOG that in the INIT mode.
Model
Application Mode
Pan ID
Node ID
RF Channel
Switch the Dip Switch 1 (DIP_1) of the ZT-20xx-IOG module to INIT mode.
③
Restart the power of the ZigBee Converter and the ZT-20xx-IOG module,
④
wait for the green LED (ZigBee) of the ZT-20xx-IOG module changing to
steady lit, that means the wireless communication established, and then
ICP DAS, ZT‐20xx‐IOG SERIES Quick Start, Version 1.0.0
Copyright
Safe Value (Router), Check-Router-Alive (Coordinator)
Pan ID, RF Power, Refresh Interval
ZT-20xx-IOG
N/A
INIT default to 0x3FFF
INIT default to 0x0020 Fixed to 0x0000 as a ZigBee Coordinator
Set by Rotary switch
©
2016 by ICP DAS Co., Ltd. All Rights Reserved.
Channel Offset (DI/DO)
ZT-USBC
N/A
Set to 0x3FFF by software
Same with the Rotary switch of the ZT-IOG.
ZT-2550, ZT-2570
Transparent Mode
Page 5
Advertisement
