HOLT ADK-8400 Quick Start Manual page 9

Evaluation board isolated discrete sensor with ±800v isolation

Hide thumbs Also See for ADK-8400:

Table of Contents

Testing Sense Thresholds

1. In GND/Open mode, VGTHL is 4.5V min and VGTHH is 10.5V max. This can be tested by

connecting a voltage source to the Sensor1 input pins on connectors J3, J8, J10 and J14. Make

sure the ground connection is connected to the GND reference for this channel. Set the Sense

Input voltage to 0V, then press the short cut 'z' key to run the monitor program, all four sensors

U3 will be read in a loop, as shown below.

2. Now increase the voltage source up to 9V, then increase the voltage slowly, to 10.5V, LED1

Arrow.com.

Downloaded from

Monitoring the four sensors above, it can be seen that sensor 1 is high. Press any key to exit

this function.

The screen above is monitoring U3 sensors, '0000' means all sensors are reading low.

and LED S1 on the board should be lit, the screen should now read 1000, as shown below:

Holt Integrated Circuits

Table of Contents

Hi-8400