Vega VEGACAP 35 Operating Instructions Manual page 29

Ʋ Max.
Switching current
Ʋ Min.
Ʋ Max.
Breaking capacity
Ʋ Min.
Ʋ Max.
Potential separation
Contact material (relay contacts)
Modes (switchable)
Switching delay
Ʋ When immersed
Ʋ When laid bare
Ʋ In the event of a fault
Ambient conditions
Ambient temperature on the housing
Storage and transport temperature
Process conditions
Process pressure
Process temperature
VEGACAP 35 • Relay (DPDT)
253 V AC, 253 V DC
With circuits > 150 V AC/DC, the relay contacts must be
in the same circuit.
10 µA
3 A AC, 1 A DC
50 mW
750 VA AC, 54 W DC
If inductive loads or stronger currents are switched
through, the gold plating on the relay contact surface will
be permanently damaged. The contact is then no longer
suitable for switching low-level signal circuits.
> 500 V DC
AgNi (Au plated) or AgSnO (Au plated)
A (overfill protection)/B (dry run protection)
0.7 s
0.7 s
1 s
-40 ... +80 °C (-40 ... +176 °F)
-40 ... +80 °C (-40 ... +176 °F)
-1 ... 16 bar/-100 ... 1600 kPa (-14.5 ... 232 psig)
See following diagram
See following diagram
9 Supplement
29