Starting The Engine - TOHATSU MFS 2.5C Owner's Manual

26
ENGINE OPERATION
ENOM00045-G

2. Starting the engine

ENOW00958-1
Do not remove or install the top cowl
after the engine has started.
The exposed rotating engine parts cause
serious injury.
ENOW00959-0
The top cowl must be installed while the
engine running except in an emergency. If
the top cowl is not installed correctly, water
splash can damage the engine.
ENOW00036-1A
7
When starting the outboard motor in the
test tank, make sure that:
1. Water level is at least 10 cm (4 in.) above
the anti-ventilation plate to avoid over-
heating of the engine.
2. Run at idling only
3. Remove the propeller
(See page 50)
3
2
1. Test tank
2. Water
3. Over 10 cm (4 in.)
WARNING
CAUTION
CAUTION
1
ENOF00863-0
ENOW00036-1
CAUTION
Operating outboard motor without cooling
water will lead to overheating and damage on
the outboard motor severely. In case the
cooling water check port is not discharging
water, stop the outboard motor immedi-
ately, check for any object, debris which may
be blocking the cooling water check port. If
you are unable to locate the cause, consult
an authorized dealer immediately.
ENOW00032-B
CAUTION
Do not try to crank after engine has started.
1. Be sure to install the stop switch lock
to the stop switch, and attach the
stop switch lanyard securely to the
operator or to the operator's PFD
(Personal Flotation Device.)
1. Stop switch lock
1
ENOF01609-1