TOHATSU MFS 2.5C Owner's Manual page 50

50
INSPECTION AND MAINTENANCE
ENOW00928-1
If gear oil is spilled, wipe off immediately and
dispose according to the local regulations.
ENON00032-1
Note
If the gear oil color appears to be milky
color, contact your dealer.
ENOM00232-A
Propeller replacement
ENOW00084-0
10
Do not begin propeller removal and instal-
lation procedure with spark plug caps
attached, shift in forward or reverse,
main switch at other than "OFF", engine
stop switch lock attached to the switch,
and starter key attached, or engine could
accidentally start leading to serious per-
sonal injury. Disconnect battery cable if
possible.
The propeller edge is thin and sharp. Wear
the groves during replacement to protect
your hands.
ENOF01619-0
CAUTION
WARNING
ENOW00086-1
CAUTION
Do not install propeller without thrust
holder, or propeller boss could be dam-
aged.
Do not reuse split pin.
After installing split pin, spread bend both
end of the pin apart to lock propeller in
place.
A worn-out or bent propeller will lower
the motor's performance, and cause
engine trouble.
1. Pull out the split pin from the propel-
ler boss and remove the propeller
from the shaft.
1
1. Shear pin
2. Propeller
3. Split pin
2. Remove the shear pin from the shaft.
3. Apply waterproof grease to the pro-
peller shaft before installing a new
propeller.
4. Install the propeller with a new shear
pin.
2
3
ENOF00242-0