TOHATSU MFS 2.5C Owner's Manual page 47

Description
Sliding and Rotating Parts
Grease Nipples
Outer Equipment
Anode
*1: Have this handled by your dealer.
ENON00030-1
Note
It is highly recommended that your outboard motor to go through complete inspection at 300
hours of use.
ENOM00091-B
Engine oil replacement
ENOW00091-1
CAUTION
You may be injured due to high engine tem-
peratures if you fill engine oil just after oper-
ation. Engine oil should be changed after the
engine has been cooled.
ENOW00092-1
CAUTION
Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper limit
marks of dip stick, drain oil to level lower
than upper limit.
Be sure that outboard motor is upright
when checking or changing oil.
Stop the engine immediately if low oil
pressure warning lamp or oil leak is found,
or engine could be severely damaged.
Consult your dealer.
Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
Inspection intervals
First 20 Every 50 Every 100 Every 200
hours or 1 hours or 3 hours or 6 hours or 1
month months months year
INSPECTION AND MAINTENANCE
Inspection procedure
Apply and pump in grease.
Check for corrosion.
Check for corrosion and defor-
mation.
ENOW00090-0
CAUTION
Use of engine oils that does not meet these
requirements will result in reducing engine
life, and other engine problems.
ENOW00933-0
CAUTION
Engine oil mixed with dust or water will dra-
matically shorten the life of the engine.
To change engine oil:
Be sure to use recommended engine oil
(see page 13).
1. Stop the engine and cool down in a
vertical position.
2. Put an oil drain pan under the oil drain
screw.
3. Remove the oil drain screw and com-
pletely drain oil from the engine.
47
Remarks
Replace if nec-
essary.
10