Electrodes Adjustment - Unigas E115X Manual Of Installation - Use - Maintenance

MultiBloc VD Mounting
1
2
1. Position VD on VB, fig. 2+3.
2. Slide VD forward up to the stop, fig. 4.
3. Screw VD on with 2 M5 screws for each, max. 5 Nm/44 in.-lb., fig. 5/6.
4. VD can be mounted rotated by 180°, fig. 7.
Removing the combustion head
Remove the top H.

Slide the UV detector from its housing.

Unscrew the two screws S holding in position the washer and then unscrew VRT to free the threaded rod AR.

Slacken the screws V holding the gas manifold C, slacken the connectors B and remove the complete assembly as shown in

figure.
Note: for the subsequent assembly carry out the above described operations in the reverse order, checking the correct position of the
OR ring.
V C
AR
OR
VRT
S

Electrodes Adjustment

Important Note: Check the ignition and detection electrodes after removing/adjusting the combustion head.Adjust the electrodes posi-
PART IV: MAINTENANCE
3
VD
position
VB
H
4
to push
5
B
48
6
7