Operation; Start-Up And Normal Operation; Starting The Ups On Battery; Ups Shutdown - Eaton 5P 650 AU User Manual

4. Operation

4.1 Start-up and Normal operation

To start the UPS:
1. Verify that the UPS power cord is plugged in.
2. The UPS front panel display illuminates and shows EATON logo.
3. Verify that the UPS status screen shows
4. Press the
The UPS front panel display changes status to "UPS starting...".
5. Check the UPS front panel display for active alarms or notices. Resolve any active alarms before
continuing. See "Troubleshooting" on page 18.
If the
panel to view the active alarms. Correct the alarms and restart if necessary.
6. Verify that the
are powered and protected.
The UPS should be in Normal mode.

4.2 Starting the UPS on Battery

Before using this feature, the UPS must have been powered by utility power with output enabled at
least once.
Battery start can be disabled. See the "Cold start" setting in "ON/OFF Settings" on page 11.
To start the UPS on battery:
1. Press the
a status of "UPS starting...".
The UPS cycles through Standby mode to Battery mode. The
The UPS supplies power to your equipment.
2. Check the UPS front panel display for active alarms or notices besides the "Battery mode" notice
and notices that indicate missing utility power. Resolve any active alarms before continuing.
See "Troubleshooting" on page 18.
Check the UPS status from the front panel to view the active alarms. Correct the alarms and restart
if necessary.

4.3 UPS Shutdown

To shut down the UPS:
1. Press the
The UPS starts to beep and shows a status of "UPS shutting OFF ...". The UPS then transfers to Standby
mode, and the

4.4 Operation on Battery Power

Transfer to battery power
• The connected devices continue to be supplied by the UPS when AC input power is no longer available.
The necessary energy is provided by the battery.
• The and
• The audio alarm beeps every ten seconds.
The connected devices are supplied by the battery.
Page 16
button on the UPS front panel for at least 2 seconds.
indicator is on, do not proceed until all alarms are clear. Check the UPS status from the front
indicator illuminates solid, indicating that the UPS is operating normally and any loads
button on the UPS front panel until the UPS front panel display illuminates and shows
button on the front panel for three seconds.
indicator turns off.
indicator illuminates solid.
.
indicator illuminates solid.
620-00082-01-au (en)