Panasonic Palmcorder VHSC PalmSight PV-L759 Service Manual page 76

16 Idler Arm Unit
PARTS
Hole A
Pin A
16 Idler Arm Unit
1. Removal of the Idler Arm Unit
(1) To remove the Idler Arm Unit, pull the Idler Arm
Unit slightly from the Chassis to release Pin A from
Hole A. Then, remove the Idler Arm Unit while turning
as indicated by the arrow.
Reassembly Note:
1. Installation of the Idler Arm Unit
(1) Set the Idler Arm Unit so that Portion B is in Hole B as
shown.
(2) Turn the Idler Arm Unit slightly as indicated by arrow
to set Pin A in Hole A.
Pass
Hole B
Portion B
Chassis
Bottom View
(3) Install Cut Washer (C-1).
Fig. DM13
Hole B
Portion B
(C-1)
Pin A
Hole A
2-28
PARTS 17 Mechanism Support Angle
(S-1)
Fig. DM14
Guide Pins
17 Mechanism
Support Angle