Panasonic Palmcorder VHSC PalmSight PV-L759 Service Manual page 45

HOW TO USE TP BOARD KIT
TP Board Kit is required when:
1. performing "Tape Interchangeability Adjustment."
2. performing "EVR Adjustment."
3. the cassette tape is jammed. Refer to "How to remove a
jammed tape (Electrical Method)," page 1-22.
4. loading or unloading the Mechanism (Electrical Method).
How to connect the TP Board Kit:
(1) Remove a Screw and remove the EVR Cover. Then,
open the Cassette Cover by sliding the EJECT button
with Power ON, or sliding the Lock Lever through TP
Board slot. Remove the Cassette Cover for "Tape
Interchangeability adjustment," OR release only 2
Locking Tabs (L-1) of the Cassette Cover for "EVR
Adjustment." Refer to "Disassembly/Assembly Proce-
dures of Cabinet," page 2-2.
(2) Slide the CF Card Connector Unit as shown.
CF Card Connector Unit
Fig. 5-1
(3) Install the Lock Screw to the Cassette Up Unit to use
the cassette tape.
Refer to "How to Hold the Cassette Up Unit in the down
position without Cassette Cover installed," page 1-14.
(4) Connect the TP Board Kit to S301 as shown.
TP Clip 36P
(LSUP0005C)
Fig. 5-2
Note:
When inserting the TP Clip to S301 on the camcorder, pinch
the grips and be sure that the label is set to the right side as
shown in Fig. 5-2.
Slide
Main
C.B.A.
CF Card
(S301)
Connector
Unit
TP Board
slot
TP Adjustment
P.C.B. 40P
S301
(VFKW0123B)
Grips
Label
TP Adjustment
Cable 40P
(LSUP0005A)
Signal description on TP Adjustment P.C.B.
40P (VFKW0123B)
Pin No.
1 GND
2 IRIS
3 GND
4 (Not used)
5 IRIS OPEN/CLOSE SW
6 EVR MODE
7 CAM +4.5V
8 EVR SERIAL DATA 1
9 V-SYNC
10 EVR SERIAL DATA 0
11 CAMERA RESET (L)
12 NC
EVR SERIAL CLOCK
13
14 NC
15 A/D SIGNAL
16 NC
17 NC
18 LUMINANCE
19 NC
20 LOADING MOTOR 0
21 LOADING MOTOR 1
22 SUPPLY REEL PULSE
23 RESET (L)
24 SAFETY TAB BROKEN (L)
25 PB CTL PULSE
26 SUPPLY PHOTO TR (L)
27 CAP FG
28 CNR
29 H-SYNC
30 PB LUMINANCE
31 YNR
32 ENVELOPE
33 HEAD SW
34 (Not used)
35 GND
36 GND
37 REC CHROMINANCE
38 REC LUMINANCE
39 (Not used)
40 (Not used)
1-24
Signal