Kohler Power Systems 8RESV Service Manual page 65

Status Message
Load Shed 1 Status Info
Load Shed 2 Status Info
Load Shed 3 Status Info
Load Shed 4 Status Info
Load Shed 5 Status Info
Load Shed 6 Status Info
* Programmable Interface Module (PIM) required.
[ Load management device required (LCM, load shed kit, or RXT with combined interface/ load management board).
Figure 4-5 Status Messages Displayed on the RDC2 Controller
TP-6881 7/15
Action
Notice The digital output for LoadPriority1Shed
[
is active (contacts closed), indicating the
1st priority load shed (load management
device) has been activated.
Notice The digital output for LoadPriority2Shed
[
is active (contacts closed), indicating the
2nd priority 1st priority load shed (load
management device) has been activated.
Notice The digital output for LoadPriority3Shed
[
is active (contacts closed), indicating the
3rd priority 1st priority load shed (load
management device) has been activated.
Notice The digital output for LoadPriority4Shed
[
is active (contacts closed), indicating the
4th priority 1st priority load shed (load
management device) has been activated.
Notice The digital output for LoadPriority5Shed
[
is active (contacts closed), indicating the
5th priority 1st priority load shed (load
management device) has been activated.
Notice The digital output for LoadPriority6Shed
[
is active (contacts closed), indicating the
6th priority 1st priority load shed (load
management device) has been activated.
Description/ Comments Check
Remove loads as required.
Check building wiring for
proper load distribution.
Check engine fuel supply.
Remove loads as required.
Check building wiring for
proper load distribution.
Check engine fuel supply.
Remove loads as required.
Check building wiring for
proper load distribution.
Check engine fuel supply.
Remove loads as required.
Check building wiring for
proper load distribution.
Check engine fuel supply.
Remove loads as required.
Check building wiring for
proper load distribution.
Check engine fuel supply.
Remove loads as required.
Check building wiring for
proper load distribution.
Check engine fuel supply.
Section 4 Troubleshooting 65