Stairville LED Vintage Bowl50 RGBA User Manual page 28

Operating
Operating mode 'Show/Master'
Operating mode 'Slave'
LED Vintage Bowl50 RGBA LED Vintage Bowl30 RGBA
28
LED PAR
Press [M]. Press one of the arrow buttons repeatedly until the display shows 'LINE' . Press [OK].
Press one of the arrow buttons repeatedly until the display shows 'MA' . Press [OK]. Now you
can select one of the 42 preprogrammed automatic shows. Use the arrow buttons to select a
value between 1 and 42 (display shows 'P-01' ... 'P-42' ).
The automatic show can only be activated on the device, that serves as master.
This setting is only relevant if the device is not controlled via DMX. The device can operate in
stand-alone mode or control connected devices of the same type, that must be configured as
slaves. When the display shows the desired value press [OK] to confirm the selection and then
[M] to return to the parent menu. To return to the parent menu without making changes, press
[M].
Press [M]. Press one of the arrow buttons repeatedly until the display shows 'LINE' . Press [OK].
Press one of the arrow buttons repeatedly until the display shows 'SL' . Press [OK]. Now you can
set the number for the device via which it is addressed by the master as a slave. Use the arrow
buttons to select a value between 1 and 512 (display shows 'A001' ... 'A512' ).
This setting is only relevant if the device is operating as Slave controlled by a Master, but not
via DMX. When the display shows the desired value press [OK] to confirm the selection and
then [M] to return to the parent menu. To return to the parent menu without making changes,
press [M].