Page 2
Congratulations on the purchase of your new Kraus plumbing fixture! Please keep the box and packaging materials until your product is completely installed. If you have any questions, require technical assistance or have any problems with your product: DO NOT RETURN TO STORE...
Make sure you have all necessary parts by checking the diagram and · parts list. If any part is missing or damaged, please contact Kraus Customer Service at 800-775-0703 for a replacement. Read all instructions and safety warnings and ensure you have all tools, ·...
Page 4
Diagram and Parts List A. Spray Head E. Escutcheon B. Faucet Body F. Base Plate C. Mounting Hardware G. Escutcheon Mounting Hardware G1. Bolt C1. Rubber & Metal Washer C2. Mounting Nut G2. Plastic Nut H. 2.5 mm Hex Wrench C3.
Faucet Dimensions 4 5/8" (116.6mm) 10 3/4" (271.6mm) 8 1/2" (215mm) 1 3/4" (46mm) 3/8" Compression Ø 1 3/8" (34mm) R1 1/4" 2 3/8" (30.3mm) (60.6mm) 10" (255.6mm) 1/4" (7.9mm) * Optional Deck Plate Installer Tip: Shut off main water supply before installing new faucet.
Page 6
Step 1. Remove mounting hardware Shut off the water supply. Remove the old faucet. Clean the mounting surface. Remove the mounting hardware (C) from the faucet body (B). Step 2. Install the faucet assembly (without deckplate) Before installation, ensure that the flange (D) is placed on the bottom of the new faucet assembly (B).
Page 7
Step 3. Install the escutcheon Before installation, remove the flange (D). Screw the bolts (G1) into the escutcheon (E) and ensure that the base plate (F) is pressed onto the escutcheon (E) before the escutcheon (E) is installed over the three holes on the sink.
Page 8
Step 5. Secure the faucet assembly Install the plastic washer and metal washer (C1) onto the threaded mounting shank. Thread the nut (C2) onto the mounting shank. Lock the nut (C2) into position by tightening the screws (C3). Do not overtighten. Step 6.
Page 9
Step 7. Flush and check for leaks Pull the hose assembly out of the spout and remove the spray head by unscrewing it from the hose in a counterclockwise direction. Hold the end of the hose down into the sink and turn the faucet on to the warm position.
Troubleshooting If you have followed the instructions carefully and your faucet still does not work properly, take the following corrective steps: PROBLEM CAUSE ACTION Leakage under faucet handle The bonnet nut (14) has come loose Tighten the bonnet nut. Clean or replace and the ring on the cartridge is dirty the cartridge or damaged...
Page 12
Kraus warrants the structure and finish of the Faucet to be free from defects in material and workmanship under normal usage for as long as the original purchaser resides in the residence in which the Faucet was first installed.
Page 13
TO THE MAXIMUM EXTENT PERMITTED BY APPLICABLE LAW, THIS WARRANTY DOES NOT COVER, AND KRAUS USA PLUMBING, LLC SHALL NOT BE LIABLE FOR, ANY SPECIAL, INCIDENTAL OR CONSEQUENTIAL DAMAGES (INCLUDING LABOR CHARGES TO REPAIR, REPLACE, INSTALL OR REMOVE THIS PRODUCT), WHETHER ARISING OUT OF BREACH OF ANY EXPRESS OR IMPLIED WARRANTY, BREACH OF CONTRACT, TORT, OR OTHERWISE.
Page 14
IMPORTANT Register Your Kraus Product Activate Your Warranty Access Premium Customer Support Get Product Information REGISTER TODAY http://www.kraususa.com/registration www.kraususa.com...