Table of Contents
Advertisement
(3) Method of manual REF. point return
1) In order to manual reference point return, the conditions below should be satisfied
before returning to the 1st reference point.
- Machine ready status.
- Not machine lock status.
- Q-setter should be up.
- Jog traverse of axis should be possible.
2) The 1st reference point return is as follows.
- In case of pressing +/- direction jog switch of each axis once and releasing.
(Jog switch one touch type)
① Manual reference point return of X, Z
1
2
3
4
5
[Jog or handle mode]
Press the switch shown in left side, then the
machine mode becomes jog mode or handle
mode.
[Traverse X, Z-axis to reference point return
possible position]
Above all, traverse the axis to the position (-
direction) that is possible to return to the 1st
reference point.
[Selecting Ref. Pt. mode]
When the axis is returned to reference point,
press reference point return switch after
checking whether the interference or collision is
occurred or not.
Press + direction switch.
The selected axis will return the 1
point. And The icon shown in left side will be
displayed in the second line in machine
operating screen.
st
reference
OPERATION | 33
Advertisement
Table of Contents
