Siemens PUMA V400/M Operation Manual page 105

■ M127
STRADDLET TOOL UNCLAMP
•
•
•
■ M132
OIL MIST COLLECTOR ON
 Function
Run the Oil Mist Collector.
■ M133
OIL MIST COLLECTOR OFF
 Function
Stop the Oil Mist Collector.
■ M138
COOLANT FLUSHING ON
 Function
Run the coolant flushing.
■ M139
COOLANT FLUSHING OFF
 Function
Stop the coolant flushing.
■ M180
TURRET CW ROTATION
 Command
M180 can be used as sole command before commanding T-code. In addition, it can
be used in the same block with T-code. It is one-shot M-code.
 Function
When tool index is progress in automatic mode, it will rotate in the direction of CW(in
the front turret) not a short distance. If tool index is done, the next tool index rotates in
the direction of short distance.
Rotate turret in the direction of CW.
However, above command is not modal. Once tool index is done, the method of tool
index returned its original way of short distance direction.
Function
Unclamp Straddle Tool.
Completion of Command
M-code will be finished after the time set in TM26 passed by.
Condition of Function
In the case that straddle tool is used, the machine is Gang Type and alarm
relating to T-code, Tool does work.
PROGRAMMING | 97