Table of Contents
Advertisement
➀ Sister tool number : Sister tool number.
➁ D : Edge number.
➂ Data set: Save number from 1 to 100. If TLM set, number assigned manually.
➃ CH1~CH6: there are up to 6 measurement sections in each Data set. Channel can be
assigned manually. The axis assignment is possible at the setup screen.(Figure 10)
➄ Function mode: special function for spindle (refer to Special function section of this
manual.(Figure 23)
➅ If TLM(Tool Load Monitoring) detects a certain value of off-range, this box will be check.
When tool is broken, If you want to re-use this tool location with new tool, you have to
uncheck the checkbox ( If you want to use sister tool, the checkbox of broken tool will be
checked automatically.)
PROGRAMMING | 107
Advertisement
Table of Contents
