Table of Contents
Advertisement
Owner's Manual
Protrusion Hazard
Incorrect
Bolt and T-Nut Assembly
Tap T-nut into the provided hole. Insert your bolt through the
lock washer and insert into the provided hole opposite from the
T-Nut. Turn clockwise to thread into T-nut. Do not completely
tighten until instructed.
Bolt and Barrel Nut Assembly
Insert barrel nut through the lock washer and press the pair
through the provided hole. Insert your bolt through the second
lock washer and insert the pair into the provided hole opposite
from the barrel nut. Turn clockwise to thread into the barrel nut.
Do not completely tighten until instructed.
Lag Assembly
Normally there will be a pre-drilled pilot hole on assemblies
that require a Lag Screw. If there is no pilot hole, line up the two
boards as they are to be attached and use the factory drilled hole
as a guide to drill another pilot hole into the adjoining board.
Th is will keep the wood from splitting. Only a lock washer is
required for steps with Lag Screws.
If you see exposed
threads and your bolt
protrudes beyond the
T-Nut you may have over
tightened the bolt or
used incorrect hardware.
If you've overtightened,
remove the bolt and add
washers to eliminate the
protrusion.
Proper Hardware Assembly
Assembly Tips
BOLT
BOLT
LAG SCREW
9
Correct
1/8"
T-NUT
LOCK WASHER
BARREL NUT
LOCK WASHER
LOCK WASHER
LOCK WASHER
Advertisement
Table of Contents
