Using The Web Interface; Logging Into The Web Interface - Cambium Networks ePMP Series User Manual

Using the web interface

This section describes how to use the ePMP web interface.

Logging into the web interface

⚫
Logging into the web interface
Perform the following procedure to log into the web interface as a system administrator.
Equipment and tools
ePMP device connected to the power supply by Ethernet cable.
⚫
PC is connected to the power supply by Ethernet cable.
⚫
Power supply powered up.
⚫
Minimum supported browser version – Chrome v29, Firefox v24, Internet Explorer 10, Safari v5.
⚫
Procedure
1. Verify that the device and power supply are connected correctly (the device Ethernet port is
connected to the power supply Ethernet power port (Gigabit Data+Power or 10/100Mbit
Data+Power).
2. Configure the host machine with an IP address in the 169.254.1.x subnet (excluding 169.254.1.1).
3. Configure the host machine with an IP address in the 169.254.1.x subnet (excluding 169.254.1.1).
4. Connect the power supply to power mains.
5. From the browser, navigate to the device's default IP address 169.254.1.1.
Log in with admin username and admin password.
6.
Chapter 4: Using the Device Management Interface 170