Table of Contents
Advertisement
DESCRIPTION OF PRODUCT
Parts description (Fig. A)
1.
Top handle
2.
Knob with bolt x 2
3.
Lower handle
4.
Transportation handle
5.
Grass catcher
6.
Rear flap
7.
Cable clip
8.
Switch box
9.
Switch lever
Check the delivery parts (Fig. B)
Remove the machine from its packaging carefully and make sure that all of the following parts
are present:
a.
Lawnmower with upper handle
b.
Lower handle
c.
Grass catcher
d.
Knob with bolt x 2
e.
Fixing screw x 2
f.
Cable clamps (2x)
g.
Manual
h.
Pull relief (for the power cable)
WARNING: If any parts are damaged or missing, do not operate this tool until
these parts have been replaced. Failure to heed this warning could result in serious
personal injury.
NOTE: Always recycle the packaging in accordance with local recycling guidelines.
14
INSTALLATION
WARNING!
-
Always check the mounting plates before assembling the wheels. Never attach the wheel
on a damaged or loose mounting plate.
-
The wheels must be assembled on the same height level. Using a product with wheels
assembled on different height level may cause damage of the cutting unit (e.g. cutting
device, spindle etc.) or an unsatisfactory result.
The bottom part of the handle is connected to the lawn mower and does not wobble.
Mounting the lower handle bar (Fig. C)
1.
Insert the lower handle bars into the supports. Ensure the mounting holes in the lower
handle bars are aligned with the ones in the supports.
2.
Secure the lower handle bars with the screws and tighten them with a suitable crosshead
screwdriver.
Mounting the upper handle bar
1.
Remove the bolts from the knobs and keep them handy.
2.
Attach the upper handle bar to the lower handle bars and align the holes in the upper
handle bar with the ones in the lower handle bars. (Fig. D)
3.
Secure the upper handle bar with the knobs and bolts to the lower handle bars and
tighten the knobs clockwise.
4.
Fix the power cord with the cord clips to the handle bars. (Fig. E)
Mounting the grass catcher
1.
Fit the upper part onto the lower part by fixing all the outer clips correctly (Fig. F).
2.
Hang the grass box on to the hook (Fig. G).
15
Advertisement
Table of Contents
