Table of Contents
Advertisement
3-2
Chapter 3: Hardware Installation
Installation Procedures
1. Locate the Display Mount within 4 meters (13 ft.) of the host terminal.
2. Determine if the cable should be routed down through the mounting surface or if
3. If you are installing with a post greater than 215 mm (8.5 in.) secure the Base Plate
4. Route the display end of the Interface Cable through the Table–Top Mount, the
it should be run on top of the surface. Drill a hole if necessary.
with screws (4) that are appropriate for the mounting surface.
Display Post, and the Display Swivel.
Note: The terminal end of the Interface Cable is too large to fit down through the
post.
Display End of the
Interface Cable
Display Swivel
(Included with pole kit)
Display Post
Table Top Mount
Terminal End of the
Interface Cable
22930
33186
Advertisement
Table of Contents
