Bit Wiegand Connector Wiring - Essex Electronics K1 Series Installation Instructions Manual

26 Bit Wiegand Connector Wiring


CONFIGURATION
PINS- "CONFIG"
YELLOW- Audio Control
(Do NOT apply voltage)
PINK- Site Code PGM
(Do NOT apply voltage)
TAN- Earth Ground
BLUE- CCTV
VIOLET- NOT USED
NOTE: The 2x6 connector is rotated 180 degrees
PINK- Site Code Program
This Keypad is capable of having the SITE CODE programmed in
the field. The PINK wire is used for this procedure.
With no voltage applied to the Keypad, connect the PINK wire

to the BLACK wire on the wiring harness. Apply the appropriate
voltage to the RED and BLACK wires. You will hear 4 rapid audible
beeps and both the RED and GREEN LED's will flash at the same
rate.
Enter the desired SITE CODE (between 0 and 255) on the Key-

pad and press # for enter. You will again hear 4 rapid audible beeps.
Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com
VOLTAGE SELECT
(Do NOT apply voltage)
12-24V (default)- Jumper on
one pin only
5V- Jumper on both pins
BROWN- LED Control
(Do NOT apply voltage)
BLACK- Ground
ORANGE- Buffered Input
(Do NOT apply voltage)
RED- Input Voltage
WHITE- Data 1's
GREEN- Data 0's
9