Essex Electronics K1 Series Installation Instructions Manual page 9

Keypad Reset
In certain cases you may want to erase all user codes and restore
system defaults. To perform this procedure:
CAUTION: This procedure completely erases the memory and
restores factory defaults! Once the memory is cleared, all pro-
grammed User Codes are erased and factory default settings are
restored.
1. Remove power.
2. Jumper the two pins above the connector labeled "CONFIG."
3. Apply appropriate power. (You should hear 4 beeps and the
RED LED will flash and the GREEN LED will be solid).
4. Once the Keypad is in configuration mode, enter 0099#. The
Keypad will beep twice and both LEDS will flash for approxi-
mately 10 seconds. (During this time, the Keypad will appear
dead. Do NOT remove power!)
5. Once the reset is complete, you will hear 4 beeps and the RED
LED will flash and the GREEN LED will be solid.
6. Enter the configuration number followed by #.
a. Keypad Output
Keypad Output
26 Bit Wiegand (default)
8 Bit Word
BCD
Serial ASCII
ABA Track II Clock & Data
4 Bit Word
Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com
Configuration Site Code
1 # 000
2 #
3 #
4 #
5 #
6 #
5