Keypad Connector Diagram - Essex Electronics SKE-34B Installation And Instruction Manual

Keypad Connector Diagram

CONFIGURATION
PINS- "CONFIG"
YELLOW- Anti
Tailgate/Internal Alarm
(Do NOT apply voltage)
PINK- Remote Bypass
(Do NOT apply voltage)
TAN- Earth Ground
GRAY- Normally Closed
BLUE- Common
VIOLET- Normally Open
NOTE: The 2x6 connector is rotated 180 degrees.
CAUTION: Do NOT run this low voltage wiring in conduit with or
adjacent to line voltage wiring.
RED- +Voltage, 27VDC Max
BLACK- Ground
YELLOW- Anti Tailgate
If not used, this must be connected to BLACK. By adding a door
monitor switch between YELLOW and BLACK, the door will relock
immediately after opening. If the third output is set up as an Internal
Alarm, this switch will trigger the alarm if the door is opened without
a code or if the door is left open longer than the Door Ajar Time
setting.
Essex Electronics, Inc. | 805.684.7601 | 800.KEY-LESS | fax 805.684.0232 | keyless.com
VOLTAGE SELECT DC ONLY
(Do NOT apply voltage)
12-24V (default), 27VDC Max -
Jumper on 1 pin only
5V- Jumper on both pins
BROWN- 24-hr Access (Do
NOT apply voltage)
BLACK- Ground
ORANGE- Program (Do NOT
apply voltage)
RED- Input Voltage
WHITE- Output A
GREEN- Output B
3